Inputs - Sony DXC-390P Instructions For Use Manual

Connecting to Video Equipment with RGB or S-Video Inputs
CCDC-5/10/25/50A/100A cable or
CCXC-12P02N/05N/10N/25N cable*
DC IN/VBS
DXC-390P
VIDEO OUT
DC IN/VBS
TRIG IN
LENS
MENU LOCK
OFF ON
RGB/SYNC
REMOTE
*If a CCXC cable is used, the S-video signal is also output from the S-video output of the
CMA-D2CE*/D2MDCE.
a) When using a video monitor without a sync signal input connector, the camera
can be set to output a sync signal with the G signal or RGB signals.
For details, see "SYSTEM menu" on page 26.
b) This setup is for connecting to a composite video (VBS) connector. To output
separated Y/C signals to the S-video input of video equipment, use a CCMC-
9DS camera cable.
For details on switching camera output between VBS (composite video) and Y/
C, see "SYSTEM menu" on page 26.
* CMA-D2CE is intended for general purpose use. It is not intended for medical use.
38
Basic System Connection
1
2
CAMERA (4-pin or 12-pin)
Camera cable: CCXC-9DBS
y
(D-sub 9-pin BNC
connectors), or CCMC-9DS
y
(D-sub 9-pin BNC,
S-video connectors)
RGB/SYNC
or
Camera cable CCXC-9DD
y
(D-sub 9-pin D-sub 9-pin)
Set the MODE
selector to the
CMA-D2CE*/D2MDCE
"1" position.
camera adaptor
Equipotential ground
terminal (only for
CMA-D2MDCE)
R input
G input
B input
a)
Sync input
Composite video (BNC) or
b)
S-video input (4-pin)
RGB/SYNC input
Power cord
RGB monitor,
image
processor, etc.
Computer,
image
processor etc.