Installation And Connections; Installation; Applicable Lens; Mounting A Microscope - Sony DXC-390P Instructions For Use Manual

Installation and Connections

B

Installation

Applicable Lens

C-mount lenses with the following lens
mount surface can be attached to the camera.
4.3 mm or
less
Note
Be sure to use a lens whose projected part
from the lens mount surface is less than 4.3
mm. Mounting the lens with a projected part
greater than 4.3 mm may damage the
internal mechanism of the camera.

Mounting a Microscope

Adaptor

To attach the camera to a microscope, an
operating microscope, etc., it is necessary to
mount an appropriate adaptor. The method
for mounting the adaptor is the same as for
the lens.
For details, refer to the instruction manual
for each adaptor.

Mounting on a Tripod

Install the supplied tripod adaptor using the
three screw holes (M3) on the top or bottom
panel. Then attach the tripod to the adaptor
using the following mounting screws:
U1/4", 20 UNC
= 4.5 mm ± 0.2 mm
(ISO standard)
Lens mount surface
Attaching the supplied tripod
adaptor
Following is an example of attaching the
tripod adaptor to the bottom panel of the
camera. You can also attach the tripod
adaptor to the top panel of the camera.
e.g. Attaching on the bottom panel

Mounting to a Wall or Ceiling

Attach the camera with the tripod adaptor to
the mounting bracket or suspension bracket
using the appropriate screws (U1/4", 20
UNC) that fit the tripod holes of the adaptor.
M3 screws
Tripod adaptor
35
Installation