Front Panel Terminology - Barco R9002110 Owner's Manual

Location and Functions of Control
External loudspeakers : Connection for external loud-
7
speakers, left and right side.
Projector Pilot Lamp : Indicates the status of the projector.
8
- Unlit : mains (power) switch is not pressed.
- Lit : mains (power) switch is pressed and the indicated
color shows the projector mode:
Green color : operational mode of the projector.
Red color : standby mode of the projector.
Important : projector ("Operational" or "Standby") mode is
defined during the installation of the projector. (Refer to a
qualified technician for change).
Depending on the hardware set-up of the projector during
installation, the projector switches to 'Standby' or to 'Op-
erational' mode. If in standby, the standby LED lights up.
9
75 ohm Termination Switch forVideo signals
VIDEO Input (Composite video, 2x loop-through BNC
10
connector): Allows a video tape recorder, video camera,
color receiver/monitor, etc. having video line output to be
connected to the projector.
75 ohm Termination Switch forS- Video signals
11
S-VIDEO Input: Separated Y/C (luma-chroma) signal in-
12
puts and outputs for higher quality playback of Super VHS
signals (4-pin S-VIDEO connector loop-through).

FRONT PANEL TERMINOLOGY

a. Gaining access to the keyboard
To reveal the keyboard in the front portion of the
retroprojector, push with one finger on the indicated
place of the keyboard door. The door will pivote to the
front and the local keyboard and the RCU will accessi-
ble.
2-2
Port 4/5 : RGB-S Input (5x BNC connector):
13
RGB-S input : allows a character generator, microcom-
puter, video camera, etc. having analog RGB output to be
connected to the projector.
Line inputs: - Signals RED-GREEN-BLUE
- COMPOSITE sync. signal
- Tri level sync signal (option)
Port 3
14
RGB Analog Input (9 pin female sub D connector). Allows
a character generator, microcomputer, etc. having ana-
log RGB outputs to be connected to the projector.
15 Communication Port (800 peripherals)
* Allows communication between the RCVDS switcher
and the projector.
* Allows connection of a remote IR receiver unit to the
projector.
16
AC Power Input : Plug always plugged in.
17
AC Power Swtch : Always pressed.
General AC Power Input : Plugged in the power connec-
18
tor from the wall outlet.
5975188 RETRODATA 808S 210397