Table of Contents
Advertisement
Location and Functions of Control
Back light key : When activated, all keys will be lit up and
1
visible in the dark.
2
ADJ. : Adjust key, to enter or exit the adjustment mode.
Address key (recessed key), to enter the address of the
3
projector (between 0 and 9).
followed by pressing one digit button between 0 and 9.
STBY : Stand by button :
4
- To initiate remote power up operation
- To stop projection without main power off.
Pause : To blank the image, press PAUSE. The image
5
disappears but full power is retained for immediate restart-
ing.
Mute : Press this key to temporarily turn off the sound. To
6
return to its previous level, press the key once again.
Help : Not active.
7
Digit buttons : Direct input selection.
8
Sound controls : Use these buttons to obtain the desired
9
sound level.
Picture controls : Use these buttons to obtain the desired
10
level (see also 'Controlling') for each picture function.
11
Phase : Not active
TEXT : When adjusting one of the image controls during a
12
meeting, the displayed bar scale can be removed by press-
ing 'TEXT' key first. To re-display the bar scale on the
screen, press 'TEXT' key again. 'TEXT' key is only active in
operational mode. When 'TEXT' is off, no warning message
will be displayed.
2-4
Press the address key,
FREEZ : To freez the projected image (only active when a
13
line doubler is built in).
ENTER : To start up the adjustment mode or to confirm an
14
adjustment or selection in the adjustment mode.
EXIT : To leave the adjustment mode or to scroll upwards
15
when in the adjustment mode.
Control disk : To make menu selections when in the
16
adjustment mode. Also allows to increment or decrement an
adjustment in the adjustment mode.
Control disk up = up arrow in the menus
Control disk down = down arrow in the menus
Control disk to the right = arrow to the right on the menus
Control disk to the left = arrow to the left on the menus
RC operating indication : Lights up when a button on the
17
remote control is pressed. (This is a visual indicator to check
the operation of the remote control)
Power switch : to switch on and off.
18
Depending the hardware set-up of the projector during
installation, the projector switches to 'stand-by' or to 'opera-
tional mode'.
Projector Pilot Lamp : indicates the status of the projector.
19
- Unlit : mains (power) switch is not pressed.
- Lit : mains (power) switch is pressed and the indicated color
shows the projector mode :
Green color : operational mode of the projector.
Red color : standby mode of the projector.
Important : projector 'operational' or 'standby' mode is de-
fined during the installation of the projector (refer to a
qualified technician for change).
Mono/Stereo : To switch the sound reproduction between
20
mono, pseudo stereo, stereo or spatial stereo.
5975188 RETRODATA 808S 210397
Advertisement
Table of Contents
