Connecting A Rgb Analog Source To Port 3 - Barco R9002110 Owner's Manual

Connections

Connecting a RGB Analog source to port 3.

Connect your RGB source via an interface to Port 3.
Always use an interface when a computer and local monitor have to
be connected to the projector.
Available Barco interfaces :
Universal analog interface
RGB 120 MHz analog interface R9826570
VGA interface 120V
230V
MAC interface 120V
230V
MAGIK interface 120V
230V
RGB analog input with automatic sync detection. (Separate H and
V sync inputs, with composite sync input or with sync signals on
green)
Pin configuration D9 connector of the Analog input.
1 Not connected
2 Ground RGBS
3 RED
4 GREEN
5 BLUE
6 Ground RGBS
7 Ground RGBS
8 Hor/comp. sync
9 Vert. sync
Analog Input Selection :
Press digit button 3 on the RCU or the local keypad.
Connecting a RGB Analog source to port 4/5.
RGB analog input terminals with separate H and V sync inputs,
composite sync input or sync signals on green (automatic sync
detection). Automatic sync polarity detection.
Always use an interface when a computer and local monitor have to
be connected to the projector. See 'Connecting a RGB Analog
source to port 3' for a list of BARCO interfaces which can be applied.
RGB input selection :
(RGB : R, G, B signals with automatic sync detection)
Press digit button 4 or 5 on the RCU or the local keypad.
3-4
R9826100
R9828079
R9828070
R9828059
R9828050
R9828129 & R9828128
R9828120 & R9828121
L
RS232 IN RS232 OUT IR REMOTE R
L
RS232 IN RS232 OUT IR REMOTE R
R L
PORT 4/5
ANALOG INTERF. 120MHz
ON
INPUT
B
OFF
G
R
R L
PORT 4/5
ANALOG INTERF. 120MHz
ON
INPUT
B H
V
OFF
G
R
INP INP
75 o h m t erm. in ver.
5975188 RETRODATA 808S 210397
H V
INP INP
75 o h m t erm. in ver.