Signal Input Connection To The Projector - Barco R9002110 Owner's Manual

Connections
When starting up the projector, with the power switch or via the stand-by key, the
projector can start up in two ways if the "CRT run in" cycle option is switched OFF.
- full white image (projector warm up) or
- immediate image display.
The way of starting up can be set in the service mode.
Start up with full white image.
The next menu will be displayed for 30 seconds.
a. Start up with warm up period.
If no action is taken, a white image will be displayed for 20 minutes.
This white image will be shifted on the faceplate of the CRT to avoid a CRT burn in.
During this warm up period, it is possible to interrupt this white image projection by
pressing the EXIT key. The previous menu will be repeated for another 30 seconds but
the remaining time will be indicated.
If EXIT is pressed, the remaining warm up period will be skipped.
During the warm up period, every 30 seconds a text box with the remaining time will be
displayed on the screen for 2 seconds. This text box will be displayed each time in a
different place.
If another key, different from EXIT, is pressed, a text box with following text will be
displayed :
Please use <EXIT> to leave this procedure.
b. Start up without warm up period.
If the EXIT key is pressed, the warm up period will be skipped and the projector is
immediately ready for use.
Warning : skipping this warm up procedure can reduce the initial picture quality
of the projected image.

Signal Input Connection to the Projector :

- Composite Video
- S-Video
- RGBS or RGsB
- RGB3S or RG3sB (option)
Port No Projector input
1 Comp. Video
1
2 S-Video
2
3 RGB
2
4/5 RGB
4/5 Component video
4/5 RGB with Tri level sync
4/5 Component video
with Tri-level sync
Only available when the optional Tri-level sync module is installed.
3-2
Press Digit Button
/Comp. Video*
3
4
5
RS232 IN RS232 OUT IR REMOTE
1
1
2
1
2
3
4 or 5
3
6
4
7
5
* Video or S-Video : switchable in the Picture Tuning
8
PROJECTOR WARM UP
A FULL WHITE PATTERN
WILL BE GENERATED FOR
20 MINUTES.
FOR IMMEDIATE USE OF
THE PROJECTOR, PRESS
WARNING : SKIPPING THIS
PROCEDURE CAN REDUCE
THE INITIAL PICTURE
QUALITY OF THE PROJECTED
THIS OPTION CAN BE
DISABLED IN THE SERVICE
R L
L
R
PORT 4/5
2 4 5 3
Input signal Y/C (luma/chroma)
Input signal : R, G and B with automatic sync detection
between seperate sync (separate composite sync or
with separate Hor and Vert. sync) or sync on green
(composite sync) and with automatic sync polarity
detection.
Input signal : R-Y, Y and B-Y with separate composite
sync or with separate Hor and Vert. sync or with
composite sync on Y.
Input signal : R, G and B with separate Tri level sync
or with Tri-level sync on green.
Input signal : R-Y, Y and B-Y with separate Tri level
sync or with composite Tri-level sync.
menu.
5975188 RETRODATA 808S 210397
<EXIT>.
IMAGE.
MENU
REMAINING
PROJECTOR
WARM UP
TIME
18.5MIN
PLEASE USE
<EXIT> TO
LEAVE THIS
PROCEDURE