Table of Contents
Advertisement
Input selection
Port No
Projector input
1
Comp. Video
2
S-Video
1
/Comp. Video*
3
RGB
4/5
RGB
4/5
Component video
4/5
RGB with Tri level sync
4/5
Component video
with Tri-level sync
Only available when the optional Tri-level sync module is
installed.
*
Video or S-Video : switchable in the Picture Tuning menu.
With the digit buttons on the RCU, it is possible to select input
sources, Video, S-Video, RGsB or RGBS, RG3sB or RGB3S.
When a valid and available source is selected, there will be informa-
tion displayed on the screen about that source (if "Text" is on). This
information includes :
- Source number
- Horizontal frequency
- Vertical frequency
When the entry is a non valid source
number, a warning appears on the screen : 'input not available'.
5975188 RETRODATA 808s 210397
When a valid source number is selected, the projector will display this
source or it will wait on the selected source number until the source
Press Digit
Button
1
2
3
4 or 5
6
becomes available. A message 'source not available' will be dis-
played for a short time.
7
Analog Picture Controls
8
The analog picture controls can be adjusted with the RCU. The
control keys are located on the lower right side of the key panel of the
RCU and indicated with the name of the control and an icon.
When an analog picture control is pressed, a text box with bar scale
and the function name of the control, e.g. 'brightness...' appears on
the screen (only if 'TEXT' is ON). The length of the bar scale indicates
the current memorized setting for this source. The bar scale changes
as the + or - buttons of the control are pressed.
Brightness Control
A correct 'brightness' setting is important for good image reproduc-
Source 2
tion. Adjust the brightness with the + or - button (RCU) until the
Fh= 15.6 kHz
Fv= 50 Hz
darkest parts of the picture appear black.
A bar scale gives a visual indication on the screen of the current
brightness setting while pressing on the above indicated keys. If the
bar scale is not visible on the screen, press ' TEXT ' key once and retry
the above indicated keys.
The bar scale increases when pressing on the + button (higher
brightness) and decreases when pressing on the - button (lower
brightness).
Contrast Control
A correct 'contrast' setting is important for good image reproduction.
Adjust the contrast to the level you prefer, according to room lighting
conditions. If the Contrast Control is too low, the picture will be too
dim. If it is set too high, the picture may be too bright and not sharp.
A bar scale gives a visual indication on the screen of the current
WARNING
contrast setting while pressing the + or - buttons (RCU). If the bar
input not
scale is not visible on the screen, press ' TEXT ' key once and retry the
available
above indicated keys.
The bar scale increases when pressing on the + button (higher
contrast) and decreases when pressing on the - button (lower
contrast).
Controlling
WARNING
source not
available
BRIGHTNESS
35
189
4-3
Advertisement
Table of Contents
