Table of Contents
Advertisement
Service Mode
Identification
Highlight 'Identification' with the control stick and press ENTER .
The 'Identification' screen gives information concerning :
- Projector address. To change the address of your projector,
contact a qualified service technician.
- Software version.
- Configuration.
possible installations :
* Front-ceiling
* Front-table
* Rear-ceiling
* Rear-table
- Baud rate PC : transfer speed for communication with an IBM PC
(or compatible) or MAC. The baud rate of the projector must be the
same as the baud rate of the connected computer. When there is
a difference, contact a qualified service technician to make the
appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator
will be displayed and if warnings and failures will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the 'TEXT' key once on the
RCU.
- Serial no. : Indicates the fabrication number of the projector. This
number can be useful when calling for technical assistance.
Copy a block
The copy a block function copies the settings of a selected block into
the active block.
Highlight copy a block with the control disk and press ENTER .
ENTER will select the highlighted item.
To copy the settings of a closed block to the block you are working
on (active block), use the control stick to select a block.
All existing settings will be overwritten with the new settings.
Press ENTER to copy the selected block. A confirmation screen will
be displayed.
If you are certain you wish to copy the contents of the selected block
into the active block, press ENTER .
EXIT cancels the copy procedure and returns without copying the
block.
8 - 2
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELTE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Select with
or
then <ENTER>
<EXIT> to return.
Proj. address : 001
Soft. Version : 6.00
Config. : Ceiling
Baudrate PC : 9600
Text : ON
Serial No. : 103589552
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELTE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Select with
or
then <ENTER>
COPY MODE
<EXIT> to return.
Nr. Src Fh
Fv
inp
1
1
15.6 50
video
2
3
31.2 60
RGB3S RT
3
-
15.6 50
intern
4
2
31.5 50
RGB3S FC
5
-
33.7 60
intern
6
7
8
Active block nr. 1
Select with
or
<ENTER> to copy
<EXIT> to return.
All settings
in current block
will be overwritten !
<ENTER> to confirm
<EXIT> to cancel
5975188 RETRODATA 808s 040697
DATA 808s
Front
conf
FC
FC
FC
COPY BLOCK
Advertisement
Table of Contents
