Connecting A Composite Video Source To Port 1; Connecting A S-Video Or Video Source To Port 2 - Barco R9002110 Owner's Manual

Connecting a Composite Video source to port 1.

Composite video signals from a VCR, OFF air signal decoder,
etc..
Video input selection :
Press digit button 1 on the RCU or the local keypad.
* Note : if using the loop-through Video output, then set the
Termination Switch to the "OFF" position.

Connecting a S-Video or Video source to port 2.

Separate Y-luma/C-chroma signals for higher quality playback
of Super VHS signals.
4 pin connector configurations:
For S-video:
Pin 1: earth(ground) luminance
Pin 2: earth(ground) chrominance
Pin 3: luminance signal(Y)
1Vpp ±3dB
Pin 4: chrominance signal(C)
300mVpp ±3dB
Input selection
Press digit button 2 on the RCU or the local keypad.
Depending on the priority setting in the 'Picture Tuning
menu', Video or S-Video can be displayed.
If the setting is not correct, start up the adjustment mode by
pushing on the ADJUST key.
Select 'Random Access' and press ENTER .
Select 'Selected source' and press ENTER .
Highlight 'Picture Tuning' and press ENTER .
Highlight Port 2 : Video and press ENTER to toggle between VIDEO
or S-VIDEO.
Press EXIT to return.
Press ADJUST to return to operational mode.
* Note: When using the Port 2 loop-through output, set the Termina-
tion Switch in the "OFF" position.
5975188 RETRODATA 808S 210397
For video:
Pin 1: earth(ground) video
Pin 2: not connected
3
1
Pin 3: video signal
Pin 4: not connected
2
4
RS232 IN RS232 OUT IR REMOTE R
Composite
video
to next projector or
to a monitor
TV tuner, e.g. TVDM40 stereo
VCR
RS232 IN RS232 OUT IR REMOTE R L
VCR S-VHS
ADJUSTMENT MODE
Select a path from below :
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
IRIS
Source 02
Choose a setup pattern
Select with
from below :
then <ENTER>
<EXIT> to return.
SELECTED SOURCE
GENLOCKED PATTERN
INTERNAL # PATTERN
R L
L
PORT 4/5
Audio
R L
PORT 4/5
to next projector or
to a monitor
Luma/Chroma
or
Source 02
RANDOM ACCESS
ADJUSTMENT MODE
Select with or
PICTURE TUNING
then <ENTER>
GEOMETRY
<EXIT> to return.
CONVERGENCE
FOCUSING
COLOR SELECT
ORBITING
CONTR. MODULATION
PICTURE TUNING
SOFT EDGE
Select with or
COLOR BALANCE
then <ENTER>
SYNC : FAST
<EXIT> to return.
PORT2 : S-VIDEO
LINE DOUBLER : ON
Select with
<ENTER> to accept
<EXIT> to return.
Connections
or
3-3