Change Password; Change Language; Run Time - Barco R9002110 Owner's Manual

Service Mode

Change password

This item is password protected.
Highlight 'change password' with the control disk and press ENTER .
The current password is displayed. The new password must consist
of 4 digits between 0 and 9. Push the control stick to the left or to the
right to select the digits to be changed. Use the numeric keys to enter
the new digits.
Press ENTER to save the new password. Before saving the new
password, a confirmation screen will be displayed.
Press EXIT to return to the Service menu without saving the new
password.
When the displayed password is correct, press ENTER to save.
If not correct, press EXIT to cancel the saving.

Change Language

The 'Change Language' function offers the possibility to change the
language of the screen menus to :
- English
- Spanish
- French
- German
Push the control disk up or down to highlight 'Change language' and
press ENTER to select the language menu.
Push the control disk up or down to select the desired language and
press ENTER to change the language.

Run time

Highlight 'run time' with the control disk and press ENTER to display
the amount of time the projector has played since its first start up at
the factory.
Note : all projectors leave the factory after a burn-in period of
approximately 100 hours.
Press EXIT to return the service mode menu.
8 - 4
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELTE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Select with or
then <ENTER>
<EXIT> to return.
PASSWORD
Enter new password :
0 0 0 0
Use and to select,
and reprogram
with numeric keys.
<ENTER> to confirm
<EXIT> to return
CHANGE PASSWORD
Password will be
reprogrammed as xxxx
<ENTER> to confirm
<EXIT> to cancel
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELTE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Select with or
then <ENTER>
LANGUAGE
<EXIT> to return.
ENGLISH
ESPAÑOL
FRANCAIS
DEUTSCH
Select new language
with
then <ENTER>
<EXIT> to return.
SERVICE MODE
IDENTIFICATION
COPY A BLOCK
DELTE A BLOCK
DELETE ALL BLOCKS
CHANGE PASSWORD
CHANGE LANGUAGE
RUN TIME
SET TO MIDPOSITION
CONVERGENCE MID
DYNAMIC ASTIGMATISM
MORE...
Select with or
then <ENTER>
<EXIT> to return.
5975188 RETRODATA 808s 040697
or
RUN TIME
105 h