Basic Configuration; Configuring Your Browser For Ap-7131N-Fgr Support - Motorola AP-7131N-FGR Product Reference Manual

3-4 AP-7131N-FGR Access Point Product Reference Guide
3. Configure the following settings:
• Baud Rate - 19200
• Data Bits - 8
• Stop Bits - 1
• No Parity
• No Flow Control
4. Press <ESC> or <Enter> to access the access point CLI.
5. Enter the default username of "admin" and the default password of "motorola."
As this is the first time you are logging into the access point, you are prompted to enter a
new password and set the county code. Refer to
available countries two digit country code.
6. At the CLI prompt (admin>), type "summary."
The access point's LAN IP address will display.
7. Using a Web browser, use the access point's IP address to access the access point.
8. Refer to
of the access point.

3.4 Basic Configuration

3.4.1 Configuring Your Browser for AP-7131N-FGR Support

An AP-7131N-FGR model access point is compliant with the FIPS140-2 standard. The AP-7131N-FGR
is only accessible using browsers that support the TLS 1.0 protocol. The AP-7131N-FGR is not
accessible by browsers supporting the SSL 2.0 or SSL 3.0 protocols. Additionally, ensure JRE (version
1.6 or above) is installed on the computer accessing the AP-7131N-FGR GUI applet. The following
sections describe how to change your browser settings using either Internet Explorer or Mozilla
Firefox in order to correctly launch and display the AP-7131N-FGR GUI applet. Without these browser
modifications, you will not be able to access the AP-7131N-FGR GUI applet.
CAUTION With both the Internet Explorer and Mozilla Firefox browser
!
Basic Configuration on page 3-4
configurations, screens may display stating Website certificates
cannot be validated or have been certified by an unknown
authority. Do not exit the browser configuration, as these
messages will occur with only the initial AP-7131N-FGR browser
configuration.
Country Codes on page A-4
for instructions on the initial (basic) configuration
for a list of each