Section 7: Screen Installation And Removal - Montigo H38DF PRC Installation & Maintenance Manual

Section 7: Screen Installation and Removal

Removing / Attaching Screens:
To Remove Screens:
Grasp each top outer corner of the screen with your
thumb and finger and pull towards yourself. When
the upper Screen Studs are free, lift the screen at an
angle from the lower slots from which the Screen
Bottom Tabs are held. Place the screen in a safe place.
To Install Screens:
Hold the screens at an angle away from the fireplace,
and locate the Screen Bottom Tabs at the lower corners
of the screen. Place the screen into the Screen Tab
Receptacles in the lower section of the fireplace.
Make sure the tabs and screens are lowered all the
way down into the Screen Tab Receptacles on the
fireplace. Then, push each Upper Screen Stud on
the top corners of the screen into the Upper Screen
Stud Receptacles in the fireplace.
Figure 25a. Screen Door Numbers (Replacement Parts)
XG0211 - 151126
Installation
Upper Screen
Stud Catch
Screen Tab
Receptacles
Figure 25b. Screen Installation and Removal
Replacement Screens:
For replacement part order numbers, please refer to section
"Replacement Parts" on page 39.
Note: Do not operate fireplace without all screens in place.
DATE
NAME
DIMENSIONS ARE IN INCHES
PC 11/26/2014
FRACTIONAL
TWO PLACE DECIMAL
A A
THREE PLACE DECIMAL
ALL BENDS ARE ASSUMED
UNLESS NOTED
OTHERWISE.
H*38DF PRC Panorama Indoor Gas Fireplace
Left Side Detail
Left Side Detail
DWG. NO.
MATERIAL
SCALE
Section:
Upper Screen
Removing
Studs
The Safet
To Remove t
Simply gra
outer corne
with your t
finger and
you. Once
Screen Stu
an angle, li
from the lo
which the S
Tabs are he
screen in a
To Install the
Holding the
angle away
fireplace, lo
Screen Bot
lower corne
screen into
Tab Recept
lower sectio
fireplace. M
tabs and sc
lowered all
into the Sc
Recepticles
fireplace. T
Upper Scre
top corners
into the Up
Stud Catch
fireplace.
Screen Bottom
Tabs
Page 23