Furuno FELCOM 250 Operator's Manual page 127

RIP settings
Click [Settings], [Network settings], [LAN] and [RIP] in the menu bar. The following
screen appears.
Item
Tx RIP to LAN
Rx RIP to LAN
Apply button
Cancel button
VIrtual router settings
Click [Settings], [Network settings], [LAN] and [VRRP] in the menu bar. The following
screen appears.
Item
Enabled/Disabled
Name
IP address
VRRP ID (1-255)
VRRP Tx interval
Priority (1 - 254)
Preempt mode
Status
Apply button
Cancel
Select RIP transmission to LAN. (None, RIP1&RIP2, RIP1,
RIP2.) Default setting: None
Select RIP reception from LAN. (None, RIP1&RIP2, RIP1,
RIP2.) Default setting: None
Click to apply settings.
Restore previous settings.
Enabled: VRRP valid, Disabled: VRRP invalid (default). The set-
tings mentioned below cannot be changed when [Disabled] is
active.
Enter name of virtual router. (alphanumeric input, a maximum of
50 characters)
Enter the IP address (IPv4) of the virtual router.
Enter VRRP ID (numeric input, 1 - 255).
Enter VRRP transmitting interval (numeric input, 1 - 99).
Enter priority (numeric input, 1 - 254).
Enable or disable the preempt mode. [ ] indicates enabled. De-
fault: enabled
Show status (Master, Backup, Error enabled/disabled).
Click to apply settings.
Restore previous settings.
6. WEB FUNCTIONS
Description
Description
6-13