Item\Method
Auto top logo
Auto bottom logo
Auto top/bottom logo extended functions
dpi: dots per inch
*1: Enabled only for the parallel interface
*2: Enabled only for South Asia font models
*3: Enabled only for ANK models
*4: Excluding some functions.
For information about the TM-T70II Utility, see the TM-T70II Utility User's Manual.
For information about how to use the memory switch setting mode, see
Setting Mode" on page
For information about ESC/POS commands, see the ESC/POS Command Reference.
Functions
Receive buffer capacity
• 4 KB (initial setting)
• 45 bytes
BUSY condition
• Receive buffer full/Offline (initial setting)
• Receive buffer full
In either case above, the printer enters the BUSY state after power is turned on, and
when a self-test is being run.
If BUSY condition is set to "Receive buffer full," the printer will not become BUSY
When the cover is open
When paper is fed by the Feed button
When printing has stopped for a paper out
When macro execution ready state
When error has occurred
TM-T70II
Utility
✔*
4
✔
✔*
4
87.
Chapter 2 Setup
Memory
ESC/POS
Switch
Commands
Setting Mode
✔
✔
✔
"Memory Switch
2
55