Connecting The Ac Adapter (Ps-180); Connecting The Ac Adapter - Epson TM-T70II Technical Reference Manual

Connecting the AC Adapter (PS-180)

Use the PS-180 or an equivalent product as the AC adapter.
 Always use the EPSON PS-180 or an equivalent product as the AC adapter.
 Should a fault ever occur in the EPSON PS-180 or equivalent product, immediately
WARNING

Connecting the AC Adapter

1
Make sure the printer's power supply is turned off and the AC adapter's
power cable has been removed from the wall socket.
2
Insert the connector of the power supply cable onto the power supply
connector (stamped 24V).
Power supply connector
 Be sure to remove the AC adapter's cable from the wall socket whenever connect-
WARNING
 Make sure the wall socket power supply satisfies the rated voltage requirements
Before removing the DC cable connector from the PS-180, make sure the power supply
cable has been removed from the AC adapter, then grasp the arrow-marked section of the
connector and pull straight out.
Using a nonstandard power supply can result in electric shock and fire.
turn off the power to the printer and remove the power supply cable from the wall
socket.
ing or disconnecting the AC adapter.
Failure to do so may result in damage to the AC adapter or the printer.
of the AC adapter. Never insert the power supply cable plug into a socket that
does not meet the rated voltage requirements of the AC adapter.
Doing so may result in damage to both the power supply and the printer.
Chapter 2 Setup
Interface board
53
2