Troubleshooting - Dyna-Glo DGJ810CSB-D User Manual

Dual fuel barbecue
Hide thumbs Also See for DGJ810CSB-D:
Table of Contents

Advertisement

Available languages

Available languages

TROUblESHOOTING

PROblEM
No gas flow or an
obstructed gas flow.
The burner will not
light using the ignitor
procedure (weak or no
spark being generated).
The burner will not
light with a match.
POSSIblE CAUSE
• T ank valve not on or fully
opened.
• Empty tank.
• P oor connection between
valve regulator and LP cylinder
coupling.
• Burner inlet blocked.
• T he ignition electrode may be
covered with grease or residue.
• T he ignition electrode may
have a loose or disconnected
wire.
• C racked or broken ignition
electrode.
• D ead battery or faulty battery
connection.
• M atch not reaching burners
(when holding match with
hand).
• Empty tank.
• P oor connection between
valve regulator and LP cylinder
coupling.
• Burner inlet blocked.
CORRECTIvE ACTION
• F ully open tank valve by turning
counterclockwise.
• C heck fuel level and replace fuel if
necessary.
• T urn off grill knobs, close the LP
cylinder value at top of cylinder
and check the connection between
the regulator valve and cylinder
coupling. Disconnect and reconnect, if
necessary.
• C lean the burner inlet (venturi) and
burner as described by the Care and
Maintenance section in the manual.
• T urn control knobs to the off position
and clean the ignition electrode with
rubbing alcohol and cotton swab.
• C heck the connection and reconnect
any loose or disconnected wires.
• R eplace ignition electrode (see
Replacement Parts List).
• P erform any of the following:
a. Replace battery.
b. Check to see if battery is
inserted correctly.
c. Check for any corrosion around
battery terminals.
d. Check wire connections as stated
above.
• U se match holder found in cabinet
door.
• C heck fuel level and refill tank if
necessary.
• T urn off grill knobs, close the LP
cylinder value at top of cylinder
and check the connection between
the regulator valve and cylinder
coupling. Disconnect and reconnect, if
necessary.
• C lean the burner inlet (venturi) and
burner as described by the Care and
Maintenance section in the manual.
33

Advertisement

Table of Contents
loading

Table of Contents