Operation; General Transmitter Layout; Fireplace Operation; Hand Held Remote Operation - Napoleon Tureen GD82NT-T Installation And Operation Instructions Manual

22

GENERAL TRANSMITTER LAYOUT

FIGURE 50

FIREPLACE OPERATION

1. Install 4 AA batteries into the receiver battery
bay as indicated on the battery cover (+/-).
2. Place the 3 position slider switch in the
"Remote" position.
3. Using the end of a paper clip, or other
similar object, insert the end of the paper
clip into the hole marked "PRG" on the receiver
front cover. The receiver will "beep" three (3) times
to indicate that it is ready to synchronize with the
transmitter.
4. Install the 3 AAA batteries in the transmitter as indicated in the
battery bay, located on the base of the transmitter.
With the batteries already installed in the transmitter, push the "ON"
button. The receiver will "beep" four times to indicate the trans-
mitter's command is accepted and set to the particular code of that
transmitter. The system is now initialized.
HAND HELD REMOTE OPERATIONS
1. Press the ON/OFF key on the transmitter, it controls all functions
of the remote. The transmitter display will show all active icons on
the screen. At the same time the receiver turns on the main burner
and a single "beep" from the receiver will confi rm reception of the
command.
2. Press the ON/OFF key on the transmitter. The transmitter LCD dis-
play will only show the room temperature and icon. At the same time
the receiver will turn the burner
off and the appliance burner turns
off. A single "beep" from the
receiver confi rms reception of the
command.
With the thermostat in the off
mode, the fl ame height may be
chosen and the main burner left
on, regardless of the room temper-
ature. To turn off the fl ame, either
turn off the on/off key or reduce
fl ame height to the off position.

TEMPERATURE DISPLAY

1. With the system in the "OFF" position, press the Thermostat Key
and the Mode Key at the same time to change the temperature from
Fahrenheit to Celsius.
2. Check the LCD screen on the Transmitter to verify that a C or F is
visible to the right of the Room Temperature display.
W415-0666 / 01.28.08

OPERATION

FIGURE 53
The remote control can operate as a room thermostat. The thermostat
can be set to a desired temperature to control the comfort level in
the room.
FIGURE 55
1. Press the Thermostat Key. The LCD display on the Transmitter
will show that the room is "ON" and the set temperature is now
FIGURE 51
displayed.
2. To adjust the set temperature, press the Up/Down Arrow Keys
until the desired set temperature is displayed on the LCD screen
of the Transmitter.
The Smart Thermostat function adjusts the fl ame height according
to the difference between the set temperature and the actual room
temperatures. As the room temperature gets closer to the set point
the Smart Function will automatically adjust the fl ame down.
1. Press the thermostat key unit the word "SMART" appears to the
right of the temperature bulb graphic.
2. To adjust the set temperature, press the Up/Down arrow keys
until the desired set temperature is displayed on the LCD screen
at the Transmitter.
FIGURE 52
The remote control has six (6) fl ame levels. With the system on and the
fl ame level at the maximum, press the Down Arrow Key once and it will
reduce the fl ame height by one step until the fl ame is turned off.
The Up Arrow Key will increase the fl ame height each time it is
pressed. If the Up Arrow Key is pressed while the system is on but
the fl ame is off, the fl ame will come on the high position. A single
"beep" will confi rm reception of the command.
FIGURE 54

ROOM THERMOSTAT

SMART THERMOSTAT

FLAME HEIGHT

FIGURE 56