Finishing; Door Removal; Shipping Bracket - Napoleon Tureen GD82NT-T Installation And Operation Instructions Manual

DOOR REMOVAL

Before the glass door can be removed, the optional front must be
removed.
The glass door is secured to the top front edge of the fi rebox. Pull the
handles of the latches forward, then lift the hooks out from the slots
in the door frame to release the top of the door. Next, pivot forward
until the top edge of the door clears the front of the fi replace. Next
gripping the sides of the door lift the door out from the retainer along
the bottom of the door.
FIGURE 36
GLASS
DOOR
OPTIONAL
FRONT

SHIPPING BRACKET

FIGURE 37
Before installing the bowl
and rocks, you must fi rst
remove the shipping bracket.
Lift up to remove.
BOWL, MESH & ROCK PLACEMENT
FINISHING SECTION
1. Carefully slide the opening in the rear of the bowl over the
burner making sure to line the holes in the bottom of the bowl with
the 2 locating pins on the burner

FINISHING

LATCHES
RETAINER
bottom. (Fig. 38)
FIGURE 38
2. Place the steel mesh inside the bowl making sure there is even
space between the mesh and edge of bowl. (Fig. 39)
FIGURE 39
3. Carefully place the rocks on the bowl by lining up the locating
notch on the underside of the rock cluster with the opening in the
rear of the bowl. (Fig. 40)
FIGURE 40
UNDERSIDE OF ROCK CLUSTER
4. After rocks have been placed on the bowl, add the remaining
rock by inserting the pin into the hole shown in (Fig. 41).
FIGURE 41
TOP SIDE OF ROCK CLUSTER
19
SCREW W/ SPACER
W415-0666 / 01.28.08