Operation; Operating Control Panel - Napoleon Astound NEFL50AB Installation And Operation Manual

operation

EN
6.0 operation
Once the appliance has been electrically connected
to a grounded circuit and the breaker is on, it is
ready to operate.
6.1

operating control panel

The control panel is located on the top right-hand corner of the appliance.
Power
Temperature
Heater
Flame
ECO Mode
Indicator
Boost Mode
Indicator
Wi-Fi Indicator
34
W415-4173 / A-0 / 11.20.23
note:
Ensure the house circuit breakers for the power
supply are turned on. In the event of a power failure,
the appliance will lose its memory function and will
reset to factory mode when the power returns.
Turn the appliance on/off.
Control the temperature of the appliance with 11 settings.
Settings:
18 ºC [64 ºF], 19 ºC [66 °F], 20 °C [68 ºF], 21 ºC [70 F], 22 ºC [72 ºF], 23 ºC
[74 ºF], 24 ºC [76 ºF], 25 ºC [78 ºF], 26 ºC [80 ºF], 27 ºC [82 ºF] and OFF.
Note:
Press and hold the button for 3s to switch between °C and °F
Turns the heater and blower on/off.
Settings:
H-0: Heater and blower off
FAN: Heater is off and blower is on
H-1: Heater and blower on
Note:
Heater control function can be enabled/disabled by holding the button for 3s. When
the heater function is disabled, "LOC" will be displayed.
Turn the flame effect on/off.
Settings:
F-1: Both orange and yellow flame on, 100% brightness
F-0: Both orange and yellow flame off
Note:
Press and hold the button 8s for Wi-Fi setup.
Indicates the appliance is working under ECO mode.
Indicate the appliance is working under Boost mode.
Indicates the appliance is connected to the wireless network.