Troubleshooting; Please Read The Following Carefully - Central Pneumatic 98898 Set Up And Operating Instructions Manual

problem
Jaws slipping.
Jaws will not open.
Stroke is too short.
Weak pulling action. 1. Low air pressure.
Leaking air.

pLeaSe reaD tHe FOLLOwing CareFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIA-
GRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANU-
FACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY
OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY
REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DIS-
TRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND
NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING
OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT
PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACE-
MENT PARTS THERETO.
SKU 98898 For technical questions, please call 1-800-444-3353.

trOUBLeSHOOting

possible Cause
Worn or damaged Jaws.
1. Loose Nosepiece.
2. Dirty Jaws.
1. Rivet pin not properly
inserted into Riveter.
2. Low oil.
3. Rivet wrong size.
2. Broken/inadequate air
compressor.
1. Poor hose connections.
2. Damaged O-Ring.
3. Dirty Air Valve or airline
inlet.
Likely Solution
Replace Jaws.
1. Tighten Nosepiece.
2. Clean Jaws.
1. Make sure that Pin is fully inserted.
2. Prime Riveter.
3. Use proper rivet length.
1. Check regulator.
2. Have compressor serviced by a qualified
technician/upgrade to compressor of sufficient
capability.
1. Reconnect using pipe thread seal tape.
2. Replace O-Ring.
3. Clean and lubricate with pneumatic tool oil.
Page 8