Wps - Draytek VigorAP 810 User Manual

Backup
Restore
After finishing this web page configuration, please click OK to save the settings.
3 . 8 . 4 W P S
3 . 8 . 4 W P S
Open Wireless LAN>>WPS to configure the corresponding settings.
Available settings are explained as follows:
Item
Enable WPS
WPS Configured
WPS SSID
WPS Auth Mode
WPS Encryp Type
Configure via Push
Button
Configure via Client
PinCode
Click it to store the settings (MAC addresses on MAC Address
Filter table) on this page as a file.
Click it to restore the settings (MAC addresses on MAC
Address Filter table) from an existed file.
Description
Check this box to enable WPS setting.
Display related system information for WPS. If the wireless
security (encryption) function of VigorAP 810 is properly
configured, you can see 'Yes' message here.
Display current selected SSID.
Display current authentication mode of the VigorAP 810. Only
WPA2/PSK and WPA/PSK support WPS.
Display encryption mode (None, WEP, TKIP, AES, etc.) of
VigorAP 810.
Click Start PBC to invoke Push-Button style WPS setup
procedure. VigorAP 810 will wait for WPS requests from
wireless clients about two minutes. The WPS LED on
VigorAP 810 will blink fast when WPS is in progress. It will
return to normal condition after two minutes. (You need to
setup WPS within two minutes)
Type the PIN code specified in wireless client you wish to
connect, and click Start PIN button. The WLAN LED on
VigorAP 810 will blink fast when WPS is in progress. It will
return to normal condition after two minutes. (You need to
setup WPS within two minutes).
91
VigorAP 810 User's Guide