Ii-3-4 Wps - Draytek VigorAP 903 User Manual

Add
Delete
Edit
Cancel
Backup
Restore
After finishing this web page configuration, please click OK to save the settings.

II-3-4 WPS

Open Wireless LAN>>WPS to configure the corresponding settings.
Available settings are explained as follows:
Item
Enable WPS
WPS Configured
WPS SSID
WPS Auth Mode
WPS Encrypt Type
Configure via Push
Button
Configure via Client
Add a new MAC address into the list.
Delete the selected MAC address in the list.
Edit the selected MAC address in the list.
Give up the access control set up.
Click it to store the settings (MAC addresses on MAC Address Filter table)
on this page as a file.
Click it to restore the settings (MAC addresses on MAC Address Filter table)
from an existed file.
Description
Check this box to enable WPS setting.
Display related system information for WPS. If the wireless security
(encryption) function of VigorAP 903 is properly configured, you can see
'Yes' message here.
Display current selected SSID.
Display current authentication mode of the VigorAP 903. Only WPA2/PSK
and WPA/PSK support WPS.
Display encryption mode (None, WEP, TKIP, AES, etc.) of VigorAP 903.
Click Start PBC to invoke Push-Button style WPS setup procedure.
VigorAP 903 will wait for WPS requests from wireless clients about two
minutes. Both ACT and 2.4G WLAN LEDs on VigorAP 903 will blink quickly
when WPS is in progress. It will return to normal condition after two
minutes. (You need to setup WPS within two minutes)
Type the PIN code specified in wireless client you wish to connect, and
48