Draytek VigorAP 810 User Manual page 69

Available settings are explained as follows:
Item
SSID
BSSID
RSSI
Ch. (Channel)
Auth.
(Authentication)
Encrypt (Encryption)
Ver. (Version)
Status
Refresh
Start PBC
PIN Start
Renew PIN
Note: When you're using PBC type WPS setup, you must press PBC button (hardware or
software) of wireless client within 2 minutes. If you didn't press PBC button of wireless
client within this time period, please press PBC button (hardware or software) of this
access point again.
Description
Display the SSID name of the access point.
Display the BSSID (MAC Address) of the access point.
Display the signal strength of the access point. RSSI is the
abbreviation of Receive Signal Strength Indication.
Display the channel number of the access point.
Display the authentication type of the access point.
Display the encryption setting of the access points. If you have
selected the access point with security setting, you have to go
to 2-7 Wireless Security to set the same security with the
access point you want to associate.
Display the version of WPS.
Display the status of WPS access point.
Click this button to refresh the AP site survey.
Click Start PBC to make a WPS connection within 2 minutes.
When using PinCode method, it is required to enter PIN Code
(Personal Identification Number Code, 8-digit numbers) into
Registrar. When the wireless station is Enrollee, the users can
use Renew PIN to re-generate a new PIN code.
Click this button to re-generate a new PIN code.
59
VigorAP 810 User's Guide