Heat & Glo 6000TRSI-AUC Installation And Operation Instructions Manual page 40

Vent Components Diagrams
Note: Heat shields MUST overlap by a minimum of 38 mm. The heat shield is designed to be used on a
wall 102 mm to 184 mm thick. If wall thickness is less than 102 mm the existing heat shields must be field
trimmed. If wall thickness is greater than 184 mm a DVP-HSM-B will be required.
384 mm
305 mm
DVP-TRAP
Horizontal Termination Cap
DVP-TRAP1
DVP-TRAPK1
Figure 3.5 DVP vent components
40
203 mm
Max
Effective
Length
Heat & Glo • 6000TRSI-AUC • 2078-900 Rev. Q • 6/10
Heat
Shield
Minimum
Term Cap
Effective Length
Trap1 79 mm
Trap2 137 mm
DVP-TRAP2
DVP-TRAPK2
Maximum
Effective Length
117 mm
238 mm