Lincoln Electric IDEALARC SP-250 Service Manual page 97

F-50
FAN MOTOR AND FAN REMOVAL AND REPLACEMENT
PROCEDURE
See Figure F.18 for fan motor and fan
removal components.
FIGURE F.18 - Fan Motor and Fan
Removal Components
1. Remove the Case Back screws.
2. Remove the gas solenoid using a
3/4" open end wrench.
3. Using a 5/16" wrench, remove the 5
screws holding the fan motor mount-
ing bracket to the case back.
4. Tilt the Case Back away from the
machine and remove the screws
holding the Case Back to the floor of
the machine using a 1/2" socket
wrench with extension.
TROUBLESHOOTING & REPAIR
IDEALARC SP-250
5. Loosen the two screws holding the
reconnect panel in place and a slide
the reconnect panel from the frame.
6. Remove the fan blade.
blade position on motor shaft for ref-
erence for replacing fan.
a. Pry the fan blade off the motor.
b. Slide the fan blade off the motor
shaft.
F-50
Note fan