Create A Room; Secondary Keypad (Controller) - Honeywell Tuxedo Touch Series Installation And Setup Manual

Notes: See "Compatible Devices" section for further information.
1. Motorized door lock bolts physically lock and unlock the door when activated, but if the door lock
installed is a non-motorized type, activation allows the door to be manually unlocked without a
2. Some thermostats do not update temperature status automatically (i.e., Wayne Dalton).
3. When using a Kwikset Smartcode Electronic Deadbolt door lock (in a Scene that is programmed to
trigger when unlocked) the Scene does not trigger if using a key; enter a user code.

Create a Room

Multiple devices can function as a group by associating them in a "Room". Follow the procedure below
to create a Room.
ICON
1. Press the Automation icon and then
press the Room Setup icon.
2. Press the Add icon and enter a room
name on the "Data Entry" keyboard.
3. Press OK.
4. Highlight the device(s) from the list that
you want to add to this Room and press
the Save icon.
Room Setup Icons
Edit
Delete

Secondary Keypad (Controller)

After all Z-Wave devices have been enrolled into the Primary Keypad (Controller), the device
information can be downloaded to a Secondary Keypad (Controller). Keep the controllers within 10 feet
of each other, apply power to the Secondary Controller and do the following:
ICON
1. On the Primary Controller:
a) Press the Automation icon from the
"Home" screen and then press the Z-
Wave Setup icon to display the "Z-
Wave Device Management" screen.
2. At the Secondary Controller:
a) Remove any Z-Wave devices that
have been added.
b) Press the Z-Wave Primary icon
(located in the lower right side of the
screen).
c) Select Yes to change this keypad to a
Secondary Controller.
Automation (cont'd)
ACTION
Add Save
ACTION
33
NOTES
Room names (i.e., All, etc.) are displayed across
the top to the screen.
Enter the new device name by entering it on the
data entry keyboard.
• Use the Shift icon for capital letters.
• Use the BS (Backspace) icon to make
corrections.
The @#$ icon is not available for use at this time.
Use the Edit and Delete icon to rename, or delete a
room.
NOTES
Note: Up to 232 Secondary Controllers can be
added.
If used for Remote Services, Tuxedo WiFi should not
be configured as a secondary controller. See the
Remote Services section.
The message is displayed: "Scanning for Devices"
The message is displayed: "Updating Devices.
Please Wait".
When the Primary Controller icon is pressed, the
message is displayed:
"Please remove all Z-wave devices from network
first"
When the device information from the Primary
key.