Night Setup Function - Honeywell Tuxedo Touch Series Installation And Setup Manual

ICON
5. To shift the primary controller role to a
handheld controller, follow the handheld
controller manufacturer's instructions.
The pop-up message disappears and
controllers have shifted successfully. Z-Wave
devices can now be enrolled from this
controller.
Note: The Z-Wave Primary Controller Shift to
Secondary icon is inactive when the Tuxedo
Touch becomes the secondary controller.
The Shift is completed when the warning
window disappears.
6. Shift the Tuxedo Touch back to the primary
controller after enrolling Z-wave devices.
First, initiate the role shift on the handheld
controller from primary to secondary referring
to manufacturer's instructions. Then, press
the Z-Wave Secondary Controller Shift to
Primary icon on the keypad.
7. Select the Z-Wave Basic Command Set On
icon to turn On all lamp modules, dimmer
On/Off switches and receptacles.
8. Select the Z-Wave Basic Command Set
Off icon to turn Off all lamp modules, dimmer
On/Off switches and receptacles.

NIGHT Setup Function

The NIGHT function can be set to arm the system in one of five arming modes:
• Away - Arms all zones with entry delay.
• Stay - Arms perimeter zones with entry delay.
• Instant - Arms perimeter zones without entry delay.
• Night (Residential Panels Only) – Arms all perimeter zones plus all zones listed in Zone List 5.
• Maximum - Arms all zones without entry delay. Not to be used for ANSI/SIA CP-01 installations.
To set the NIGHT function, do the following:
ICON
1. Press the System Setup and Advanced
Setup icon.
2. Enter your Authorized Code, if required.
3. Press the Night Setup icon.
4. Select the arming mode to be activated
when NIGHT is selected on the "Arming"
screen.
User System Setup (cont'd)
ACTION
ACTION
25
NOTES
Note: This command does not control door locks
or any other security enabled devices.
NOTES
Apply accepts the setting.
Back cancels your selection.