Before a device will work in the home control network, it must be "Enrolled" (added) into the network.
Follow the instructions below to enroll a Z-Wave enabled device into a home control network using the
Tuxedo Touch keypad
specific device.
View the Training Videos and follow the instructions below to Enroll (add) devices into
your home control network.
NOTE: Z-Wave applications have not been evaluated by UL.
WARNING: Automation is intended for lifestyle convenience. Do not use automation for life safety and
property protection.
U L
Automation functionality is supplementary only and has not been evaluated by UL.
Enrolling/Adding Z-Wave Devices
Before enrolling Z-Wave devices, each device must be installed according to the manufacturers'
instructions.
Access control functionality has not been evaluated by UL and may not be used in UL Listed
U L
applications.
Enroll/Add a Light, Switch or Outlet Module
To enroll a Z-Wave Light, Switch or Outlet module, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from
the "Home" screen and then press
the Z-Wave Setup icon to display
the "Z-Wave Device Management"
screen.
ress the Z-Wave Enroll/Add icon.
b) P
2. At the device Module:
a) Press the Function Key on the
device.
Z-Wave Device Management Icons
Remove/
Enroll/Add
Delete
Automation
and follow the instructions in the Z-Wave device User Guide for your
ACTION
Remove
Abort
Failed
Note: Z-Wave light modules may vary; follow the
instructions in the User Guide for your specific device
to enroll properly.
• If a dimmer module was added, an On/Off button
and a slide bar (to control the dimmer) are displayed.
• If an on/off light, appliance, switch or outlet module
was added, an On/Off button (to control the device)
is displayed.
The keypad displays a series of messages:
"Start add device.
Please press function key on device"
"Adding Controller Unit"
"Adding Slave Unit"
"Device added successfully"
Reset
Edit
Router
Default
27
NOTES
Security
Link