Account Setup - Honeywell Tuxedo Touch Series Installation And Setup Manual

Fixed IP Addresses
If the IP Address is not displayed in the lower left-hand corner on the Tuxedo Touch Keypad "Home"
screen, you may require a "Static" (Fixed) IP Address that can be found by accessing your router. Refer
to your router instructions for further information and then do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Setup icon and then press the
IP Setup icon; the "IP Setup" screen is
displayed.
Press the button next to Obtain an IP
b
)
address automatically to de-select.
c) Enter the "IP Address" by pressing the
first set of 3 zeros ("000") on the screen,
and enter the first three numbers of the
IP address on the "Data Entry
Keyboard". Repeat this step until the
complete address has been entered and
press Apply.
2. At your PC, Smart Phone or Tablet
Browser:
a) Enter your IP Address.

Account Setup

Account setup provides a browser log-on page for each user (for higher security) when viewing from a web enabled
device or PC on a different sub-net. To set up a user account, do the following:
ICON
To set up a User Account:
1. Press the Account Setup button.
2. If required, highlight the User
Name/Password fields on the screen and
enter the data for each on the "Data Entry
Keyboard"; press OK.
4. Press the Save icon. The new user is
displayed on the screen.
5. Press Apply.
6. To delete a user, press the Delete button
next to that user's information.
Initial Setup (cont'd)
ACTION
ACTION
10
NOTES
Use the Data Entry Keyboard to enter the
required information.
•
Use the Shift key for capital letters
•
Use the BS (Backspace) key to make
corrections.
•
Press OK
A pop-up window displays the message:
Settings Changed! Remember new settings?
Select Yes to save the settings.
Select No to cancel.
NOTES
Note: Account Setup allows you to add up to 5
users.
Use the Data Entry Keyboard to enter the
required information.
•
Use the Shift key for capital letters
•
Use the BS (Backspace) key to make
corrections.
•
Press OK
•
Press abc/@#$ to switch between letters and
symbols.
A pop-up window displays the message:
Settings Changed!
Remember new settings?
Select Yes to save the settings. Select No to
cancel.