Adjust The Screen Timeouts; Clean Screen - Honeywell Tuxedo Touch Series Installation And Setup Manual

Note: If using a Z-Wave thermostat with Celsius as your degree preference, the temperature can be adjusted
by 0.5 degree increments.

Adjust the Screen Timeouts

When the keypad is left idle, it automatically:
• Turns the "Backlight Off After" the selected backlight off time has expired (unless "Never" is selected).
• returns to the "Home" screen after the selected "To Homepage After" time has expired (unless
"Never" option is selected), and
• if enabled, the "Auto Slideshow After Time" begins the slide show.
To select the desired screen timeouts, do the following:
ICON
1. From the "Home" screen, press the
Setup icon.
2. Press the Display & Audio Setup icon.
3. Enter your Authorized Code.
4. Press the desired selection from the
drop-down list displaying the time
period for each option.
5. Press the Back icon.
Yes saves the change. No discards the change.

Clean Screen

With the exception of normal cleaning, the keypad is maintenance free.
Press the "Display and Audio" icon, and do the following:
ICON
1. Press the CLEAN SCREEN icon. A pop-up
window displays
so that you may wipe the screen clean. Please use a
damp, soft cloth. DO NOT use any liquids, sprays, or
ammonia-based cleansers. Press CONTINUE to
disable touchscreen
*Panics cannot be initiated during this process*
2. Press Cancel to exit.
IMPORTANT: Do not use an abrasive cleaning agent or abrasive cloth when cleaning the keypad or
damage to the touch screen may occur.
The Emergency screen cannot be accessed while running in the clean screen mode.
Setup (cont'd)
ACTION
ACTION
"
Touch Screen has been disabled
."
12
NOTES
If changes are made, when you exit a "Settings
Changed!" pop-up window is displayed asking
"Remember New Settings?"
Settings include:
•
Backlight Off After X time
•
Return To Homepage After X time
•
Auto Slideshow After X time.
Notes
• The "To Homepage After" Time option is only
available if the Screen Blackout (EN50131
Display) option is not enabled by the installer.
• When in EN50131 mode, "Auto Slideshow After"
is preset to "1" minute and can not be changed.
NOTES
When the "Continue" icon is pressed the
message "Touch Screen Disabled for =30
Seconds" is displayed. During these 30
seconds the touch screen should be wiped
clean of fingerprints using a mild soap solution
and a soft cloth. When the counter reaches
zero, the window automatically closes and the
touch screen is active.