Editing Z-Wave Device Names; Edit A Device Module Name; Remove/Delete Z-Wave Devices; Remove A Light, Outlet, Or Switch Module - Honeywell Tuxedo Touch Series Installation And Setup Manual

Editing Z-Wave Device Names

Edit a Device Module Name

To edit a device name, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and press the Z-Wave
Setup icon to display the "Z-Wave Device
Management" screen.
b) Highlight the device name and press the
Z-Wave Edit icon.
c) On the "Data Entry" keyboard, press Clear
and enter a new name.
d) Press OK.

Remove/Delete Z-Wave Devices

Remove a Light, Outlet, or Switch Module

To remove a device from the Z-Wave network, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the
Z-Wave Setup icon to display the
"Z-Wave Device Management" screen.
b) Highlight the device to remove and press
the Z-Wave Remove/Delete icon.
2. At the device module:
a) Press the Function Key to remove the
device from the keypad.

Remove a Door Lock Device

To remove a door lock module from the Z-Wave network, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the
Z-Wave Setup icon to display the
"Z-Wave Device Management" screen.
b) Highlight the device to remove and press
the Z-Wave Remove/Delete icon.
2. At the door lock:
a) Press the Function Key to remove the
device from the keypad.
Automation (cont'd)
ACTION
ACTION
ACTION
29
NOTES
Enter the new device name by entering it on
the data entry keyboard.
• Use the Shift icon for capital letters.
• Use the BS (Backspace) icon to make
corrections.
The @#$ icon is not available for use at this
time.
NOTES
Z-Wave Remove/Delete -clears the node
from the keypad and resets device to the
default setting.
Notes:
• If the device is not removed, refer to the "Z-
Wave Troubleshooting" section.
• To remove a defective device, refer to the
Z-Wave Troubleshooting section.
NOTES
Z-Wave Remove/Delete-clears the node from
the keypad and resets device to the default
setting.
Notes:
• If the device is not removed, refer to the "Z-
Wave Troubleshooting" section.
• When excluding the door lock, the user code
associated with the door lock will remain in
the system. If needed refer to the panel
Installation Instructions on how to remove
this user code.
• To remove a defective device, refer to the
"Z-Wave Troubleshooting" section.