Detailed Video Format Settings; Setting The Video Format In The Camera Menu - Sony SRW-9000 Operation Manual

Detailed Video Format
Settings
On this unit, you can select the video formats
listed in the following table.
Frame rate Signal format
23.98PsF YCbCr 4:2:2
RGB 4:4:4
24PsF YCbCr 4:2:2
RGB4:4:4
25PsF YCbCr 4:2:2
RGB4:4:4
29.97PsF YCbCr4:2:2
RGB4:4:4
50P YCbCr 4:2:2
59.94P YCbCr 4:2:2
59.94I YCbCr 4:2:2
RGB 4:4:4
50I YCbCr 4:2:2
RGB 4:4:4
You can check the currently selected format in the
SYSTEM screen (page 64).
You can register eight of your most frequently
used formats from the above list, which allows
you to select them on the subdisplay.
For format selection on the subdisplay, see
"Selecting the Video Formats" (page 46).
Setting the Video Format in the
Camera Menu
You can set the video format on the <OUTPUT
FORMAT> page of the MAINTENANCE menu.
The factory default settings are the 23.98PsF
frame rate and the 4:2:2 YCbCr signal format.
Referring to the procedure mentioned in "Setting
the Built-in Clock" (page 39), select
MAINTENANCE menu on the TOP MENU
screen and call up the <OUTPUT FORMAT>
page.
For details on menu operations, see "Basic Camera
Menu Operations" (page 123).
<OUTPUT FORMAT> page
Bit length
10
CURRENT
10 or 12
Display the current format.
10
SCAN
10 or 12
Select the scan mode: PROGRESSIVE or
10
INTERLACE.
10 or 12
FRAME
10
Select the frame rate. When you select
10 or 12
INTERLACE for the scan mode, select 29.97 to
10
specify 59.94I or select 25 to specify 50I.
10
SIGNAL
10
Select the signal format.
10 or 12
The compression ratio of 4:4:4 HQ is
10
SQ.
10 or 12
When the settings are completed, move the cursor
to SET FORMAT and press the MENU SEL/
ENTER dial.
The format is changed, and the new format is
displayed on the CURRENT line.
The message "UNSUPPORTED FORMAT"
appears for three seconds if the settings change is
rejected.
SELECT FPS
When the optional HKSR-9002 is installed, set
this to ON to use the Select FPS function (see
page 106).
The selected format appears on the NEXT line.
When the settings are completed, move the cursor
to SET FORMAT and press the MENU SEL/
ENTER dial.
The format changes, and the new format appears
on the CURRENT line.
Notes
• If you select an invalid format combination (e.g., 60P
and 4:4:4), SET FORMAT appears in parentheses, and
the format cannot be changed.
• The message "UNSUPPORTED FORMAT" appears
for 3 seconds if the unit is unable to change the settings
after the above operations.
1
/
2

Detailed Video Format Settings

of 4:4:4
77