System Setup Menu - Sony SRW-9000 Operation Manual

Item
MIC LEV/LIM
Microphone level and
limiter settings
(Only when INPUT SEL is
set to "ANA1", "ANA2" or
"All Analog" and the
AUDIO IN CH-1/CH-2
connector input selection
switches are set to "MIC".)
BEEP(PHONE)
Volume of beep tones
output from the
EARPHONES jack
BEEP(BOARD)
Volume of beep tones on
system board

SYSTEM Setup Menu

The SYSTEM Setup menu allows you to make system settings.
• Factory default settings are underlined.
• Square brackets indicate settings as displayed in setting windows (see page 171).
Settings
Track1 Specifies limiter ON or OFF settings for the audio levels
of microphones connected to the AUDIO IN CH-1/CH-2
Track2
connectors.
Track3
–34dB/Off, –34dB/On, –46dB/Off, –46dB/On, –58dB/Off,
Track4
–58dB/On
Track5
Track6
Track7
Track8
Track9
Track10
Track11
Track12
ALARM Specifies whether to generate alarm tones.
OFF [Off]: Do not generate alarm tones.
HIGH [High]: Generate loud alarm tones.
LOW [Low]: Generate quieter alarm tones.
WARN Determines whether to generate warning tones.
OFF [Off]: Do not generate warning tones.
HIGH [High]: Generate loud warning tones.
LOW [Low]: Generate quieter warning tones.
ALARM Determines whether to generate alarm tones.
OFF [Off]: Do not generate alarm tones.
HIGH [High]: Generate loud alarm tones.
LOW [Low]: Generate quieter alarm tones.
WARN Determines whether to generate warning tones.
OFF [Off]: Do not generate warning tones.
HIGH [High]: Generate loud warning tones.
LOW [Low]: Generate quieter warning tones.
VTR Menu List 177