Using The Ramp Function - Sony SRW-9000 Operation Manual

registered values, you can operate more quickly
by deleting it.
You can leave up to seven of the STEP numbers
(numbers 2 to 8) unregistered.
PRESET
Resets all step shutter values to the factory
defaults.

Using the Ramp Function

When the optional HKSR-9002 is installed, you
can use the ramp settings page of the subdisplay
or the <RAMP> page of the PAINT menu to
change the FPS (number of frames shot) during
shooting.
Ramp settings page
While the ramp settings page of the subdisplay is
displayed, assignable buttons 2 and 3 function as
ramp setting buttons, regardless of any other
functions that have been assigned to them (see
page 51).
Display of assignable
button 2 function
1
2 3 4
1 in the first line shows the current FPS.
Use this page to make the settings shown in the
following table.
Display of assignable
button 3 function
5 6
Figure Setting item Setting value
number
Starting FPS
2
value
Ending FPS
3
value
Ramp time
4
(seconds)
Video level
5
compensation
mode (see
page 44)
Ramp mode
6
(FPS ramp
curve)
To change a setting value: Move the cursor to
the left of the item to set, and then turn the
MENU SEL/ENTER dial.
To switch 2 (starting FPS value) and 3
(ending FPS value): Press assignable
button 2.
To execute the ramp function: Press assignable
button 3.
The FPS (number of frames shot) changes
according to the settings described above.
During execution, "*" appears to the right of
the current FPS value (1 in the figure).
1
2 3
The "*" indication disappears when
execution end, and the 2 (starting FPS
value) and 3 (ending FPS value) values are
switched.
Note
The following limitations apply during execution of the
ramp function.
Basic Settings with the Subdisplay
S23.98PsF/S24PsF: 1 to
24
S25PsF: 1 to 25
S29.97PsF/S30PsF: 1 to
30
S50PsF: 1 to 50
S59.94PsF/S60PsF: 1 to
60
0 to 30
A (Angle): Angle
compensation mode
G (Gain): Gain
compensation mode
–: No compensation
L (Linear): Linear mode
E (Exponential):
Exponential mode
–: Ramp off
Note
The ramp function is not
executed when "–" is
selected. (Assignable
button 3 does not work.)
45