Dell OptiPlex 9020 Owner's Manual page 51

Hide thumbs Also See for OptiPlex 9020:
Table of Contents

Advertisement

Error Message
Description
Reset failed
The disk re-set operation failed.
Sector not found
The operating system cannot locate a sector on the floppy or hard drive.
Seek error
The operating system cannot find a specific track on the floppy disk or hard drive.
Shutdown failure
A chip on the system board might be malfunctioning.
Time-of-day clock
The battery might be dead.
stopped
Time-of-day not
The time or date stored in System Setup does not match the computer clock.
set-please run the
System Setup
program
Timer chip counter
A chip on the system board may be malfunctioning.
2 failed
Unexpected
The keyboard controller may be malfunctioning or a memory module may be
interrupt in
loose.
protected mode
WARNING: Dell's
During initial startup, the drive detected possible error conditions. When your
Disk Monitoring
computer finishes booting, immediately back up your data and replace your hard
System has
drive (for installation procedures, see "Adding and Removing Parts" for your
detected that drive
computer type). If no replacement drive is immediately available and the drive is
[0/1] on the
not the only bootable drive, enter System Setup and change the appropriate drive
[primary/
setting to None. Then remove the drive from the computer.
secondary] EIDE
controller is
operating outside
of normal
specifications. It is
advisable to
immediately back
up your data and
replace your hard
drive by calling
your support desk
or Dell.
Write fault
The operating system cannot write to the floppy or hard drive.
Write fault on
The operating system cannot write to the floppy or hard drive.
selected drive
51

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents