Table of Contents
Advertisement
Parameter Menus
Host Serial Response Time-out
This parameter specifies how long the scanner waits for an ACK, NAK, or CTS before
determining that a transmission error has occurred. This only applies when in one of the
ACK/NAK Software Handshaking modes, or RTS/CTS Hardware Handshaking option.
The delay period can range from 0.0 to 9.9 seconds in 0.1-second increments. After scanning
the bar code below, scan two numeric bar codes beginning on page 4-68. If you make an
error or wish to change your selection, scan CANCEL on page 4-70.
HOST SERIAL RESPONSE TIME-OUT
RTS Line State
This parameter is used to set the idle state of the Serial Host RTS line. To select LOW RTS
line state, scan the bar code below. For the Dual RS-232 Synapse cable, this parameter only
applies during the data transmission. At all other times, the RTS line state is passed through
from the terminal to the host.
HOST: HIGH RTS (default)
To select LOW RTS line state, scan the bar code below.
HOST: LOW RTS
4-63
Advertisement
Table of Contents
