Host Serial Response Time-Out; Rts Line State - Symbol P470/P370 Product Reference Manual

P470/370 RF Scanner Product Reference Guide

Host Serial Response Time-out

This parameter specifies how long the scanner waits for an ACK, NAK or CTS before
determining that a transmission error has occurred. This only applies when in one of the
ACK/NAK Software Handshaking modes, or RTS/CTS Hardware Handshaking option.
The delay period can range from 0.0 to 9.9 seconds in 0.1 second increments. After
scanning the bar code below, scan two numeric bar codes beginning on page 5-104. If
you make an error, or wish to change your selection, scan CANCEL on page 5-106.
HOST SERIAL RESPONSE TIME-OUT

RTS Line State

Scan the appropriate bar code below to set the idle state of the Serial Host RTS line.
Choose LOW RTS line state or HIGH RTS line state.
*HOST: LOW RTS
HOST: HIGH RTS
5-94