Host Type; Rs-232C Host Types - Symbol LS 2104 Product Reference Manual

LS 2104 Product Reference Guide

Host Type

RS-232C Host Types

Three RS-232C hosts are set up with their own parameter default settings (Table 4-2.).
Selecting the ICL, Fujitsu, or Nixdorf RS-232C terminal sets the defaults listed below. These
defaults take precedence over standard defaults. So if you select Fujitsu RS-232C, then select
the standard defaults, the Fujitsu defaults still take precedence.
Parameter
Transmit Code ID
Data Transmission Format
Suffix
Baud Rate
Parity
Hardware Handshaking
Software Handshaking
Serial Response Time-out
Stop Bit Select
ASCII Format
Beep On <BEL>
RTS Line State
*In the Nixdorf Mode B, if CTS is Low, scanning is disabled. When CTS is High, the user can scan
bar codes.
4-6
Table 4-2. Terminal Specific RS-232C
Standard
No
Data as is
CR/LF (7013)
9600
None
None
None
2 Sec.
One
8-Bit
Disabled
Low
ICL FUJITSU
No No
Data/Suffix-1 Data/Suffix-1 Data/Suffix-1
CR (1013) CR (1013)
9600 9600
Even None
RTS/CTS None
Option 3
None None
9.9 Sec. 2 Sec.
One One
8-Bit 8-Bit
Disabled Disabled
High Low
NIXDORF
Mode A/
Mode B
No
CR (1013)
9600
Odd
RTS/CTS
Option 3
None
9.9 Sec.
One
8-Bit
Disabled
*Low = No
data to send