Installation Step - Chery QQ6 Service Manual

1.1.12. Remove two cross beams from the
instrument panel and the fixing bolts from the
soleplate with a 10# sleeve.
Torque: 10±1 Nm
1.1.13. Obliquely place the instrument panel
and instrument panel cross beam, remove the
fixing bolts from the left, middle and right sides
of instrument panel with a 10# sleeve, and take
off the bond strap.
Torque: 4±0.5 Nm
1.1.12. Detach any related harness connector.
1.1.13. Lift out the instrument panel and
instrument panel cross beam by two operators.

1.2. Installation Step

The installing steps are reverse to those for
removal.
Note:
1.2.1. The instrument panel dual-vent and A/C
vent shall be fit well, without the improper
installation and air leakage. The instrument
panel air duct and instrument panel cross beam,
evaporator and other parts shall NOT interfere
and affect the installation of instrument panel,
which may result the improper installation of
instrument panel and its accessories.
1.2.2. The instrument panel and front
windscreen shall NOT interfere and affect the
installation of instrument panel and front
windscreen, and the clearance between front
windscreens shall be uniform.
1.2.3. The clearance between the instrument
panel and both sides of body shall be uniform
and can meet the assembly of weatherproof
rubber strip of door opening.
67