Installation And Adjustment Step - Chery QQ6 Service Manual

5. Installation and Adjustment Step

5.1. The installing steps are reverse to those for
removal.
5.2. Adjustment of door
5.2.1. After the installation of door, check the
horizontial and vertical clearances and the
closing force of door. If the clearance is
incorrect and the closing force is big, timely
adjust the clearnace and force. See Body
Dimension for the adjustment of door
clearance.
5.2.2. The door clearance is adjusted by
regulating the fixing bolts of hinge at the body.
5.2.3. The closing force of door can be slightly
adjusted by regulating the position of front door
lock column.
Torque: 9±1Nm.
5.3. Adjustment of door glass regulator system.
5.3.1. Check the window regulator system after
this system is assembled. The duration of
window glass lifting from the lowest position to
the highest position shall be approximate 7 s.
If the time is too long, check the regulator in
time.
5.3.2 Check window regulator motor.
5.3.3. Check whether there is oil or dust in the
glass run channel which may result that the
resistance is overhigh when the window glass is
rising.
CAUTION: DO NOT apply any lubricating
grease on the glass run channel or glass so as to
avoid the adhesion of dust.
5.3.4. Check whether the installation of glass
guide is deviated from its proper position,
which may result that the glass is clamped due
to the nonuniform arc scale when the glass is
rising. The position of glass guide can be
adjusted by the guide fixing bolts.
33