Oki Data CONFIDENTIAL
5.5 Density control manual setting
When a printer is shipped from the factory, the automatic density correction mode has
been set in "Automatic". If a printer is used after the density correction mode is set to
"Manual", density may change during usage of a printer. Actions to be taken when
density is not normal.
Note! Perform the followings while a printer is in the still state. Do not perform the
followings during warm-up.
(1) Press the MENU
or MENU
displayed. Then, press the ENTER key.
(2) Press the MENU
or MENU
(3) Press the ENTER
key.
The automatic density correction starts.
43856301TH Rev.3
key several times until the [Calibration] is
key to display [Adjust Density Execute].
5. Maintenance Menu
116 /