Roof Mounting Options - Rinnai Prestige Operation & Installation Manual

InsTallaTIon - all sysTeMs

Roof MounTIng opTIons

These systems are not suitable for use on roofs over 10 m high�
WARNING
For roofs with a slope of 10° or less a flat roof frame must be used.
Rinnai do not recommend installing Close Coupled systems on roofs with a pitch greater than 30°� An additional
strap should be used to prevent the cylinder from tipping over if a system is installed in this manner� Refer page
28�
It is normal to mount the solar collectors down close to the gutter� Roof construction must be checked to ensure
that the roof timbers are capable of supporting the additional load� (Refer to AS 3500�4 Appendix H)�
For tiled roof installations� Check for cracked or damaged tiles in the area of proposed installation� Replace any
faulty tiles� If spare tiles are not available, swap damaged tiles with good ones from along the gutter line�
Standard Installation
Installation details are in this manual�
N
flat Roof frame
Additional information is provided in the roof frame manual provided with
the frame�
N
Reverse pitch frame
Additional information is provided in the roof frame manual provided with
the frame�
N
Side Pitch Frame
Additional information is provided in the roof frame manual provided with
the frame�
N
Cyclone frame
Additional Information is provided in the Cyclone frame manual provided
with the cyclone frame
N
Rinnai 22 CC OIM Issue 9