Roof Mounting Options - Rinnai Prestige Operation & Installation Manual

INSTALLATION - SOLAR COLLECTORS

ROOF MOUNTING OPTIONS

For roofs with a slope of 10° or less a flat roof frame must be used.
Roof construction must be checked to ensure that the roof timbers are capable of supporting the additional load.
(Refer to AS 3500.4 Appendix H).
The roof mounting option must be appropriate for the wind loading that is likely in the installed location. See the
section 'Mounting Location Suitability' on page 7.
Standard Installation
Installation details are in this manual on page the section 'Standard
Installation' on page 11. This type of installation is not suitable for use
on roofs over 10 m high.
Flat Roof Frame
For use on a flat roof or where the roof pitch is too low. This type of
installation is not suitable for use on roofs over 10 m high.
Additional information is provided in the roof frame manual provided with
the frame.
Reverse Pitch Frame
These comprise of a Split System flat roof frame and a side/reverse pitch
kit. This type of installation is not suitable for use on roofs over 10 m high.
They can be used when the collectors need to be installed in the reverse
direction to the direction the roof is facing. For example, installing on a
South facing roof enables the collectors to be oriented to the North.
Additional information is provided in the roof frame manual provided with
the frame.
Side Pitch Frame
These comprise of a Split System flat roof frame and a side/reverse pitch
kit. This type of installation is not suitable for use on roofs over 10 m high.
They can be used when the collectors needs to be installed side on to the
direction the roof is facing. For example, installation on an East or West
facing roof to enables the collectors to be oriented to the North.
Additional information is provided in the roof frame manual provided with
the frame.
Cyclone Frame
Additional Information is provided in the cyclone frame manual provided
with the cyclone frame
Rinnai 26
N
N
N
N
N
Split Solar OIM