Front And Left-Hand Cover - Intermec EasyCoder PF2i Service Manual

3.2 Front and Left-Hand Cover

All Models
Intermec EasyCoder PF2i, PF4i, and PF4i Compact Industrial—Service Manual
The front/left-hand cover is made of magnesium and is fi tted with a
number of user interface devices, see Chapter 2.
Removing the front/left-hand cover gives access to:
• The electronics incl. CPU board, AC connection, power supply, and any
optional interface pcb.
• The motor, belts, and pulleys of the media feed and the optional liner
takeup unit and ribbon feed motor.
The left-hand cover plate is fi tted to the center section using three #T20
Torx screws accessible from the media compartment.
To remove the cover, proceed this way:
• Disconnect the power cord and open the right-hand door.
The electronic compartment contains wires and components with
dangerous voltage (up to 380V). Make sure that the printer is switched
off and the power cord is disconnected before the left-hand cover is
removed.
• Using a #T20 Torx screwdriver, remove the three screws and lift the
cover up so it disengages the bottom plate.
• Swing out the rear part of the cover so you can disconnect the console
cable from the CPU board.
• Put the cover aside on a soft cloth or similar to avoid scratches.
Chapter 3—Covers and Doors
47