Understanding The Printer Front Panel - Intermec EasyCoder 3240 Getting Started Manual

HelvC

Understanding the Printer Front Panel

The front of the 3240 printer contains one button (Feed/Pause) and three light
emitting diodes (LEDs) that the printer uses to provide information during
printer operation. The three LED indicators operate as follows:
Green LED
Orange LED
Yellow LED
The Feed/Pause button performs the following functions depending on the
mode of the printer:
Print Mode
If the printer is idle:
If the printer is printing:
When the printer is first
powered on:
C o d e 39
NugFont
Power
Alert
Empty/Pause
Feed/Pause
Function
Press and release the Feed/Pause button to feed out one label
or a minimum specified amount of media.
Press and hold the Feed/Pause button to continuously feed
media until you release the button.
Press the Feed/Pause button twice to take the printer offline.
Press and release the Feed/Pause button to make the printer
pause.
Press and release the Feed/Pause button again for the printer
to resume printing.
Press and hold the Feed/Pause button to cancel the print job.
Press and hold the Feed/Pause button to print the hardware
configuration label. Refer to "Testing Printer Operation" later
in this chapter.
Preparing the Printer for Connection
LED State
Power Off
On
Off
Alert
Flashing
On
Off
Flashing
Empty/Pause
On
3240G.002
1
Indicates
Power off
Power on
Printing or idle
Over-temperature
System fault
Printing or idle
Printer is paused
Media fault
1-5