Wpa/Wpa2 - ZyXEL Communications NBG6616 User Manual

The following table describes the labels in this screen.
Table 33 Network > Wireless LAN 2.4G/5G > General: WPA-PSK/WPA2-PSK
LABEL
Security Mode
WPA-PSK
Compatible
Pre-Shared Key
Group Key Update
Timer
Apply
Cancel

11.3.4 WPA/WPA2

Select WPA or WPA2 from the Security Mode list.
Note: WPA or WPA2 is not available if you enable WPS before you configure WPA or WPA2
in the Wireless LAN 2.4G/5G > General screen.
Chapter 11 Wireless LAN
DESCRIPTION
Select WPA-PSK or WPA2-PSK to enable data encryption.
This field appears when you choose WPA2-PSK as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to connect to
your NBG6616.
WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
The Group Key Update Timer is the rate at which the AP sends a new group key out to
all clients.
The default is 3600 seconds (60 minutes).
Click Apply to save your changes back to the NBG6616.
Click Cancel to reload the previous configuration for this screen.
NBG6616 User's Guide
95