Table of Contents
Advertisement
Error messages
Display message
Base no power
or
No link to base.
Reconnect main base
AC adaptor.
or
No link.
Check Phone Line
Error
Failed
Incomplete
Memory Full
Use rechargeable
battery.
You must first
subscribe to Caller
ID.
Cause/solution
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit's AC adaptor to reset the unit. Reconnect
the adaptor and try again.
R The handset's registration may have been cancelled.
Re-register the handset (page 30).
R When "No link." is displayed during a power failure, place a
handset on the base unit to supply power to the base unit.
R The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 9).
R Recording was too short. Try again.
R Phonebook copy failed (page 22). Confirm the other handset
(the receiver) is in standby mode and try again.
R The receiver's phonebook memory is full. Erase the unwanted
phonebook entries from the other handset (the receiver) and
try again.
R The phonebook memory is full. Erase unwanted entries
(page 21).
R Message memory is full. Erase unwanted messages (page 36,
37).
R The call barred list memory is full. Erase unwanted entries
(page 29).
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 6.
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Useful Information
47
Advertisement
Table of Contents
