Wall Mounting - Panasonic KX-TG8032AL Operating Instructions Manual

DECT repeater
Installation
1
Connect the unit.
R Use only the supplied Panasonic AC
adaptor PQLV219AL.
(220-240 V AC, 50/60 Hz)
R When the unit is turned on, the
indicator and
for about 2 seconds.
2
Confirm that the
indicator light green. (The unit is ready
for use.)
R If the indicators do not light green,
re-position the unit in a place where
the indicators light green.
Note:
R The AC adaptor must remain connected at
all times. (It is normal for the adaptor to feel
warm during use.)
R The AC adaptor should be connected to a
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight of
the adaptor may cause it to become
disconnected.
R The unit can support a maximum of 3
handsets at a time.
Setting the repeater mode
This repeater is pre-registered to the base unit
and the default setting of repeater mode is
"On". You do not need to change this setting
for initial use.
44
Hook
Press plug firmly.
indicator light amber
indicator and
1
(middle soft key) #138
2
MbN: Select the desired setting. a
a M N
Note:
R After turning the repeater mode on or off,
is displayed on the handset
momentarily. This is normal and the
handset can be used once

Wall mounting

Note:
R Make sure that the wall is strong enough to
support the weight of the unit.
Wall mounting template
37 mm
is displayed.
Screws
(Not supplied)
37 mm