If The Tv Remotecontroldoesnotwork Properly After The Centerunit Is Installed(Tv Remote Repeaterfunction); If The Centerunit Cannotbe Installed On A Tv Stand(Increasingthe Heightof The Centerunit) - Yamaha Digital Sound Projector YSP-4300 Owner's Manual

Installation
Enj0ying surround effects regardless of conditions (My Surround)
The My Surround function creates rich surround sound effects ill rooms with less than optimal surround sound conditions (,_p. 11 ). See
"Changing the audio output method for surround playback" (,_ "p. 36, 37) for more information.
If the TV remotecontroldoesnotwork properly after the centerunit is installed(TV Remote
Repeaterfunction)
The TV may not respond to commands from
its reruote control if the center unit obstructs
the remote control sensor on the TV. Should
this occur, press the RI_MOTI _
RI_pI_ATI_R key on this unit's remote
TV remote control
control more than 3 seconds to set the TV
Remote Repeater function to enable. The
REPEATER indicator on the front panel
display will light.
When the TV remote control is aimed at the
center unit's remote control sensor, the TV
Remote Repeater on the back of this unit
transmits signals from the TV remote control
to the TV.
Signals from the TV remote control can be transmitted to the TV while this unit is in standby mode.
@ Note
This function can be used while the TV remote control is using infrared signals.
TV Remote Repeater
TV remote
control sensor
If the centerunit cannotbe installed on a TV stand(increasingthe heightof the centerunit)
In most cases, the center unit can be placed on a TV stand. The supplied spacers can be attached to increase the height of the unit if
necessary. Attach both the left and right spacers to the unit.
Align the protrusions on the back of the spacer with the
mounting holes on the bottom of the center unit and press
the spacer firmly into place.
Removing the spacers
Pull the spacers straight up.
Spacer
Pull the spacer straight up.
Protrusions
Mounting holes
Bottom of the center unit
12 En