Setting The Hdmi Control Function - Yamaha Digital Sound Projector YSP-4300 Owner's Manual

Hide thumbs Also See for Digital Sound Projector YSP-4300:
Table of Contents

Advertisement

Initial settings
Setting the HDMI control function
2
Enable
the HDMI control function of all
components
connected to this unit via
HDMI cable.
For this unit, set "HDM[
CONTROL"
to "ON"
(_xp. 63)9
For external
components,
refer
to the manual
supplied
with each component.
3)
Registering HDMI compatible
components to the TV 4)
7
Select this unit as the input source of the
I
TV.
Turn on an external components, such as
a Blu-ray disc player, connected to this
unit via HDMI cable.
Select the input source of this unit to
Blu-ray disc player and check whether the
image in the player is correctly displayed
or not.
If the Blu-ray
disc player
is connected
via HDM[
IN I
jack,
press
the HDMI1
key.
Input source name
i"i
Zi
4
Check if the HDMI control function works
(turn on this unit o r adjust the volume level
using the remote control of the TV),
If the HDMI control function
is not working
Be sure that all components
are correctly
connected
to this
unit, and that settings
are properly
configured
as described
below'.
The TV is connected
to the HDM[
OUT (ARC)
jack of this
unit.
"HDM[
CONTROL"
(_,: p. 63) ix set to "ON"
in the setup
menl.1.
The HDM[
control
Nnction
is enabled
on the TV. (Also
check the relative
settings
such as power
interlock
Nnction
or speaker
priority.)
When
the HDM[
control
Nnction
ix not still working
even
after the above
has been checked,
Turn off this unit and the TV, and then turn them back on
again.
Disconnect
the AC power
supply
cable
of the unit and
external
components
connected
to the unit via HDM[
cable.
Plug them in again after about
30 seconds.
After
OPTICAL,
ANALOG,
AUX,
YIT,
or USB 5) input
has been enabled,
switch
the input
source
for the TV and
this unit to the components
connected
via HDM[
cable.
Changing the connection method and
connected components
When the connected
components
and jacks
a:e changed,
reset this
unit with the following
procedure.
1
Disable the HDMI control function of the
TV and Blu,ray disc player, turn off all
{Y)
ii
i;!i¸¸
ii! _ i;_ !
_ii
<i:!
iii iiii!il}_iiii!i
ili {;il)
2) :(_s
• The del_.mlt setting is "OFF".
When "HDMI CONTROL"
is set to "ON"
When the Eco functinn (_,_p. 41 ) is emd_led, this unit enters smndb>
mode if the TV is selected lot audio output using the TV's remote
control.
s> 4<
The example of TV settings
• From the setup menu on your TV, select "Link setting" _ "HDM]
control setting", then set a setting such as "HDMI control fimction" to
"ON".
• Setting such as "Speaker priority" should be set to "AV amplifier".
4) _(_
For some HDMI compatible
components,
registering
HDMI compatible
components to TV is not required in this case when the HDMI control
function is enabled.
5) _
YSP-4300 only
31
En

Advertisement

Table of Contents
loading

This manual is also suitable for:

Digital sound projector ysp-3300

Table of Contents